Main causes of burr cutting in laser cutting machine
The main reasons for the low carbon steel cutting burr of the laser cutting machine, laser focus on the position is not correct, need to be adjusted according to the focus position test, offset focus; the laser output power is not enough, need to check the laser generator is normal, if normal, then observe the laser control numerical output button is correct. Adjust the line; the cutting speed is too slow, the need to increase the line speed in operation control; the purity of cutting gas is not enough, need to provide high quality gas cutting work; laser focal shift, need to be adjusted according to the focus position test, offset focus; machine running time is too long the instability, the need to shut down restart. Laser cutting machine for cutting stainless steel or tibnor burrs how to solve, not simply to speed up the cutting speed, because of increased speed sometimes cutting plates do not wear, this situation is particularly prominent in the processing of aluminum plated zinc plate. At this time, the other factors of machine tools should be taken into consideration, such as whether the nozzle should be replaced, and the motion of the guide rail is unstable.
return
|
